Drobbins at 15:56, 24 January 2012

2012-01-24T15:56:00Z

Oleg: Created page with "This page expains how to setup and configue '''PPPoE''' connection with rp-pppoe and Funtoo Linux network. = Kernel options = Make sure following kernel options are enabled
2012-01-24T04:49:07Z

Created page with "This page expains how to setup and configue '''PPPoE''' connection with rp-pppoe and Funtoo Linux network. = Kernel options = Make sure following kernel options are enabled <p..."

New page
This page expains how to setup and configue '''PPPoE''' connection with rp-pppoe and Funtoo Linux network.
= Kernel options =
Make sure following kernel options are enabled
<pre>
# zgrep PPP /proc/config.gz
CONFIG_PPP=m
CONFIG_PPP_BSDCOMP=m
# CONFIG_PPP_DEFLATE is not set
CONFIG_PPP_FILTER=y
CONFIG_PPP_MPPE=m
CONFIG_PPP_MULTILINK=y
CONFIG_PPPOE=m
CONFIG_PPP_ASYNC=m
CONFIG_PPP_SYNC_TTY=m</pre>
Install and configure <code>rp-pppoe</code>.
<pre># emerge rp-pppoe
# pppoe-setup</pre>
Configuration is straightforward, setup username, password and ethernet interface to use, in our example it is <code>eth2</code>.
= Funtoo Linux network setup =
Funtoo openrc does not provide default template for ppp connections. We will create a custom template.
<pre># cd /etc/netif.d/</pre>
Create <code>interface-pppoe</code>
<pre>#!/bin/sh
netif_pre_up() {
pppoe-connect >/var/log/pppoe.log 2>&1 &
}
netif_pre_down() {
pppoe-stop
}</pre>
Now we will create a <code>eth2</code> interface as follows:
<pre># cd /etc/init.d
# ln -s netif.tmpl netif.eth2</pre>
Then create an <code>/etc/conf.d/netif.eth2</code> configuration file that would specify a pppoe template in <code>/etc/netif.d</code> directory:
<pre>template="interface-pppoe"
description="Your ISP"</pre>
To complete configuration add an interface to default runlevel:
<pre> # rc-update add netif.eth2 default</pre>

← Older revision		Revision as of 15:56, 24 January 2012
Line 36:		Line 36:
	To complete configuration add an interface to default runlevel:		To complete configuration add an interface to default runlevel:
	<pre> # rc-update add netif.eth2 default</pre>		<pre> # rc-update add netif.eth2 default</pre>
		+
		+	[[Category:Networking]]
		+	[[Category:HOWTO]]