Encrypted funtoo on linode

From Funtoo
Revision as of 23:39, November 16, 2016 by Knightgats (talk | contribs)
Jump to navigation Jump to search

This howto describes how to setup a complete Funtoo Encrypted Install ( Root File System and SWAP ) using LUKS and LVM on LINODE VPS

   Note

Use Funtoo Installation Guide for reference.

Setting Linode

  • From Linode Manager create a new Linode. Under the Disks section of the Linode Dashboard, click on "Create a new Disk:"


New_Disk

  • Label your new disk image and choose an appropriate size. Here we will create "two disks" the first for root partition and another for swap. Set appropriate size for each one.


Edit_Disk

  • Select the Create a New Configuration Profile option. Assign a label, and select your disk images under Block Device Assignment.

Config_Profile
Click on Save Changes once your profile is complete.

  • Return to the Linode DashBoard, and select the Rescue tab. From there, click the Reboot Into Rescue Mode button. Your Linode will now boot into thee Finnix recovery image. Use the Lish shell to access your Linode.
  • Run the following set of commands to create a root password and enable SSH server:


root # passwd ↵
root # service ssh start ↵

At this point, you are able to connect on your VPS using SSH

root # gdisk /dev/sda

Command: x ↵
Expert command: z ↵
About to wipe out GPT on /dev/sda. Proceed?: y ↵
GPT data structures destroyed! You may now partition the disk using fdisk or other utilities.
Blank out MBR?: y ↵