Package:WPA Supplicant

From Funtoo
Revision as of 17:01, October 3, 2014 by Pytony (talk | contribs) (This does not belong to the HOWTO category)
Jump to: navigation, search

WPA Supplicant

   Tip

We welcome improvements to this page. To edit this page, Create a Funtoo account. Then log in and then click here to edit this page. See our editing guidelines to becoming a wiki-editing pro.


Configuration

You can configure wpa_supplicant daemon by editing /etc/wpa_supplicant/wpa_supplicant.conf.

   /etc/wpa_supplicant/wpa_supplicant.conf - wpa_supplicant daemon config
# provide control interface for wpa_cli and wpa_gui frontends
ctrl_interface=/run/wpa_supplicant

# allow wpa_cli and wpa_gui to update config
update_config=1

network={
	ssid="SSID"
	psk="passphrace"
}

network={
	ssid="SSID2"
	key_mgmt=NONE
}

Daemon

Start daemon with openrc.

root # /etc/init.d/wpa_supplicant start

You can also add it to default runlevel.

root # rc-update add wpa_supplicant default

The daemon can work independently or you can use wpa_cli and wpa_gui frontends. You can also alter configs with frontends.

Wpa_cli CLI Frontend

You can start cli frontend by running wpa_cli.

root # wpa_cli

Scan Access Points

> scan
OK
<3>CTRL-EVENT-SCAN-STARTED
<3>CTRL-EVENT-SCAN-RESULTS
> scan_results
bssid / frequency / signal level / flags / ssid
50:32:75:ee:b6:fb       2462    -41     [WPA2-PSK-CCMP][ESS]    AndroidAP
00:3a:98:99:12:f3       2412    -71     [WPA2-EAP-CCMP][ESS]    wEKSOTE
00:3a:98:99:12:f0       2412    -71     [WPA2-EAP-CCMP][ESS]    wULAPPA
00:23:33:a2:7d:14       2462    -85     [WPA2-EAP-CCMP][ESS]    SaitaBYOD
00:3a:98:99:12:f1       2412    -70     [ESS]   saitaOpen

Connect to Access Point

> add_network
0
> set_network 0 ssid "SSID"
> set_network 0 psk "passphrase"
> enable_network 0
<2>CTRL-EVENT-CONNECTED - Connection to 00:00:00:00:00:00 completed (reauth) [id=0 id_str=]

Save config

> save_config
OK

Wpa_gui GUI Frontend

wpa_gui is simple gui frontend. You can start it by running wpa_gui.

root # wpa_gui

Autoconfigure IP with dhcpcd

You can use Package:dhcpcd to autoconfigure ip address.

root # emerge -av dhcpcd
root # /etc/init.d/dhcpcd start