Esta página documenta las tecnologías que están soportadas en Funtoo Linux y las que no.
Cada tecnología tiene asignado un nivel de grado (A, B o C) o está marcada como no soportada oficialmente. Nos tomamos muy en serio estos niveles de grado, y una calificación "A" indica una tecnología en Funtoo que recibe un gran cuidado para garantizar una funcionalidad continua y predecible, además de una experiencia consistente para nuestros usuarios.
x86-64bit is used by the overwhelming majority of Funtoo Linux users, and most of our stage3 builds are for this architecture. Thus, it is the best supported architecture. Our
x86-64bit builds are pure 64-bit, and do not include multilib support. We include pre-built
debian-sources kernels in our stage3's for this architecture to improve ease
of installation and maximize hardware compatibility.
We also have official builds for
arm-64bit and soon
riscv-64bit. These architectures are functioning but are more challenging to install as they do not include our official pre-built kernel and may require board-specific setup. In general, the steps documented in The Installation Guide apply, except the part on boot
loader, configuring GRUB, etc.
OpenRC is the official init system of Funtoo Linux, and we explicitly do not support SystemD. Why? For a lot of reasons. We believe that an operating system's init system is one of its distinctive characteristics, and is something we care about. Gentoo used to be a leader in this area, with the first dependency-based init system being created in the early 2000's. Later, this init system was ported to C and became what is now known as OpenRC. We would rather support OpenRC going forward and look at other interesting possibilities than moving in lock-step with SystemD. We believe that the initial startup process is an area where innovation and independence is important.
SystemD has been a contentious topic in the Open Source community, and the issues with SystemD are not purely technical. They are also related to the very aggressive and coercive promotion of SystemD as being the one init system for all Linux distributions. As SystemD absorbs more and more functionality, such as device management, power management, control of your laptop's backlight, and other low-level functions, it becomes more and more embedded in the foundation of the Linux userspace stack, and distributions become more beholden to upstream SystemD changes and future 'acquisitions' of functionality. This erodes the ability of Linux distributions -- and thus Linux users --- of being in control of the low-level technologies used for various aspects of Linux. We believe it's in the best interests of the Linux community to encourage diversity and innovation in this space. We want the larger Gentoo ecosystem -- as well as Funtoo -- to support innovation, not uniformity.
Systemd is not supported in Funtoo Linux. This is a technical decision and we will not be adding systemd support to Funtoo.
In Funtoo Linux
debian-sources is our official kernel, with
debian-sources-lts also fully supported. Why Debian?
One of the goals of Funtoo Linux is to provide a
system that is ready for use in a production server environment. Debian-sources is used by many people, and thus receives
updates related to system stability that other kernels may not always receive.
debian-sources-lts is akin to using a RHEL kernel, but is more current. It also allows us to use Debian's kernel configurations, which are maintained for us by the Debian project, and enable all hardware as kernel modules. This allows us to pre-build a kernel that works for everyone, which greatly reduces the complexity of a Funtoo install, without having to perform the tremendous amount of work of maintaining our own kernel. For kernels, there is strength in numbers. The more people that are using the kernel, the more issues are found, and the more problems are fixed. In the past, Funtoo has even offered Red Hat Enterprise Linux kernels, though this was primarily
done because we were using OpenVZ containers in production and this was the only supported kernel for OpenVZ.
There may be a kernel that you personally prefer over Debian's kernel, and in an ideal world we would maintain our own Funtoo kernel and kernel configuration
for you. But at this time,
debian-sources happens to be an excellent general-purpose
kernel for nearly all users, both desktop and server, and the more advanced users are free to use whatever kernel they prefer, but then take responsibility for dealing with any issues related to that choice.
debian-sourcesis the official kernel in Funtoo Linux, and is included on stage3's for x86-32bit and x86-64bit architectures.
debian-sources-ltsis an alternate kernel that is fully supported and is often used in production server environments.
gentoo-sources is not officially supported in Funtoo Linux but may be used by advanced users. If you are experiencing possible kernel problems, we will ask you to switch to
debian-sources for troubleshooting purposes, since this eliminates kernel variation as a source of potential problems.
Multiple desktop environments are supported in Funtoo Linux, with the most well-supported of these being GNOME. This is primarily due to Daniel Robbins using GNOME as his primary desktop environment, so it is always continually tested, and it also has its own official stage3 build. If you are starting out with Funtoo, a pre-built GNOME desktop environment, installed via a pre-built GNOME stage3 is highly recommended as a starting point, even if it may not be your favorite.
Other environments, such as Cinnamon and MATE, are also supported but get somewhat less testing, although they all get built regularly. These environments rely on community testing and bug reports.
KDE has historically not gotten as much attention, although that is changing, and it is likely that we will be offering an official KDE build of Funtoo quite soon. At that point, it will likely quickly move to a 'grade A' level of support.
gnomemix-in or using our official stage3 builds.
cinnamonmix-in or using our official stage3 builds.
matemix-in or using our official stage3 builds.
lxqtmix-in. We do not have an official stage3 for it.
kdemix-in. Support is 'in progress' as it currently pulls in wayland which is not yet supported. We do not yet have a stage3 build so no regular build testing is performed. Follow FL-8510 for status on this.
Xorg is our official display technology for desktop environments. There is some possibility of adding Wayland support if there is sufficient community support for maintenance and testing.
Wayland is not currently officially supported in Funtoo Linux. This may change at some point as more users are available to test and maintain it. Discussion related to this can happen in FL-9073.