Note

The Funtoo Linux project has transitioned to "Hobby Mode" and this wiki is now read-only.

Install/Setting the Date/en

From Funtoo
< Install
Revision as of 22:21, September 11, 2018 by FuzzyBot (talk | contribs) (Updating to match new version of source page)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search
Install Guide, Chapter 7 < Prev Next >
   Important

If your system's date and time are too far off (typically by months or years,) then it may prevent Portage from properly downloading source tarballs. This is because some of our sources are downloaded via HTTPS, which use SSL certificates and are marked with an activation and expiration date. However, if your system time is relatively close to correct, you can probably skip this step for now.

Now is a good time to verify the date and time are correctly set to UTC. Use the date command to verify the date and time:

root # date
Fri Jul 15 19:47:18 UTC 2011

If the date and/or time need to be corrected, do so using date MMDDhhmmYYYY, keeping in mind hhmm are in 24-hour format. The example below changes the date and time to "July 16th, 2011 @ 8:00PM" UTC:

root # date 071620002011
Fri Jul 16 20:00:00 UTC 2011

Once you have set the system clock, it's a very good idea to copy the time to the hardware clock, so it persists across reboots:

root # hwclock --systohc